R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable. Check my rate
Free collection from
Century City, Cape Town
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Tuesday, 14 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 1 business day. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
Main centres:
1-3 business days
Regional areas:
3-4 business days
Remote areas:
3-5 business days
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
3DP-005241
Bob Shop ID:
577621418
Description:
These silicone socks will keep your nozzle clean and free from burnt and blackened plastic. They don't just keep the nozzle clean but also help keep heat inside the hotend.
They also offer a huge boost in temperature stability, particularly if you use high airflow active cooling around the nozzle. The additional cooling combined with reduced heat from the block, the heater sock helps optimize the thermodynamics taking place just below the nozzle, boosting the ability to print great overhangs and bridges all while keeping the hotend temperature extremely stable.
Socks don't last forever though. Depending on what materials you print and how much abuse they get, they eventually wear near the nozzle tip. However, even with sticky abrasive materials and a bit of abuse, they should easily last 100+ print hours.
