Name: Single Channel 5V Relay Breakout Board
SKU: 3914
Price: 46.28 ZAR
Availability: InStock

Single Channel 5V Relay Breakout Board

New

2 available

Indicative market price: R50.91

Only 2 left – grab it before it’s gone!

R46.28

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

PiShop SA2728

98.41 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

3914

Bob Shop ID

660420000

The Relay breakout board is a convenient board to be used with 5V microcontrollers such as SK40C, SK28A, Arduino, SKds40A, SK18B. You can easily use 5V signal to control the relay. Three inputs:

VCC = 5V is needed
GND = Common Ground, 0V
IN = Control signal need to be 5V 0V to activate the Relay (Active Low)

The relay terminals (COM, NO, and NC) are brought out using a 3-way screw terminal. On-board relay is rated at 10A. It can be used in many applications: controlling high voltage, high current loads such as motor, solenoid valves, lamps, and AC load. It also comes with 2 LEDs to indicate the status power (VCC) and the status of the relay.

Note: This is an active-high active-low device, which means logic high (5V) low (0V) at pin IN will trigger the relay.