This item has closed 1 buyer bought 1 item
View other items offered by Tuya Smart Home SA75
Smart Energy Monitor 2x Clamp Meter | 80A CT Single Phase | WiFi Tuya Smart Life
New
R1,290.00
Closed
8 Apr 24 00:01
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Product code:
HT-SCM-2-80
Bob Shop ID:
605710687
Smart WiFi Intelligent Current can be used in any application up to 80A to accurately measure the power consumption. The unit makes use of 2x Clamp Meters or CT's (current transducers). The benefit of these units is that they merely 'clamp onto the power cable' and are therefore non-intrusive and simple to install. The unit can for example be used to monitor your total power consumption and for example your geyser and pool pump etc. The main control unit is very small and DIN rail mountable and can therefore be fitted to your DB.Can be used to make any home, office or factory 'Smart' while monitoring the amount energy used. By adding Smart Switches you can also Switch (ON/OFF) any device based on a preset current limit from this device. e.g. above a certain current switch OFF the geyser and ON again below a certain value etc. IF THIS, THEN THAT principle. All this remotely via your phone from any location (free Tuya app).Note:
Typical Uses (but not limited too)
- Does not require any wiring, simple and fast to install. Ensure to SITCH OFF all power before fitting the clamps.
- The unit is for single phase (230VAC) home, rental units, small office, geyser, power saving etc.
- Smart products can be switched ON/ OFF when certain current thresholds are reached.
- The CT's are directional and must be placed with the arrow pointing towards the load.
Product Name | Single Phase - 230VAC - Power Clamp |
Material | Plastic |
Function | Measures real-time Voltage, Current, Power Factor, Active Power and Total energy consumption. |
Wi-Fi | 802.11 B/G/N20/N40 |
RF Characteristics | Operating frequency: 2.4GHzInternal AntennaOutput Power: Up to +20dBm |
Operating Voltage | 90~250 VAC 50/60 Hz |
Calibrated Metering Accuracy | 100W Within 2W>100W Within 2% |
Reporting Cycle | Every 2 seconds |
CT Provided | CT 80A (default) |
Clamp diameter | 80A: 10mm |
Operating environment | Temperature: -20 ~+55 Humidity: 90% non-condensing |
Dimension (module itself) | (L) 46.1 x (W) 19 x (H) 46.2 mm |
- Manage the Power Consumption of your home of any 3x specific devices in an office or factory.
- Verify the electrical consumption of tenants (in apartments, holiday home etc.) or any department or office section.
- Verify your Pre-Paid electricity consumption.
- Useful when used with 'current power saving' applications.
- Large pumps and or any machinery
- Can be 'clamped to any existing DB (Distribution Board)
- Does not require any re-wiring, simple and fast to install. Ensure to SITCH OFF all power before fitting the clamps.
- 1x Smart Switch 3x Energy Meter
- 1x External WiFi Antenna
- 3x CT clamps 80A
- 1x Instruction Manual