Solar Water Tank Water Level Controller Plastic Float Ball Valve
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
613379666
100% Brand New and High QualityThis valve is the replacement of the traditional float ballcock, which can be applied to various systems of high water tanks, pools, water towers of the industry and civil construction, etc.Automatic control, low self-complementary water, water full automatic stop.Four intakes, large volume of waterBeautiful appearance, small size, practical, simple installation.Without electricity, easy to use, long life, low failure rate, saving water resourcesWhen the pool or tank water levels fall, the valve body will sink down and then the forerunner of the control valve will be opened. As the pipe water pressure affects, the seal face of control valve will be opened. Finally the water comes out and vice versaSpecifications:Type: Upright Inner InstallationWorking pressure range: 1-10KG(0.1-1MPa)Applicable Medium: clean waterApplicable Medium temperature: less than equal 70Resistance to high temperature medium temperature: 70~120Outlet Diameter: G1/2Size: 100.2x58x50mmQuantity: 1 Pccolor: Whitematerial: plasticPackage Contents:1*Water level control valveNote:This production belongs to the liquid level control valves. When installed, the float must be vertical. if you need to install from the top , a Elbow needed to connect the float valve and the inlet line. Firstly, the feed line should be fixed in horizontal plane and then connect the automatic water level control valve on the water inlet according to the standard. The main water inlet should be lined with the control valves' Normal Diameter. When using, the globe valve should be all open. If two valves are installed in the same pool, the two valves should be held in the same horizontal plane. Before installing, please clean the impurities in the pipes in case of blocking.If the water quality is not good, then the valves need to be maintained properly.If the users find the time of adding water becomes longer, he can just upload the water inlet and make it washedOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.