Sound and Light Prompt Alarm Water Leakage and Overflow Waterproof Detector
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD01550872
Bob Shop ID
593698810
1. Weight: 160g
2. Dimensions: 7.27.2cm
3. Material: ABS
4. Specifications: voltage DC 9V, alarm current 0.08mA, sound greater than 120dB, 9V alkaline battery power supply (not included the battery)
5. Features: beautiful and practical, lightweight and portable, detachable design, high sensitivity, loud and easy to identify, waterproof and moisture proof, replaceable battery, durable
6. Scope of application: kitchen, bathroom, laundry, drinking fountains and other places with faucets or water storage
7. Alarm for water leakage detection:
-Place your finger under the water leak alarm and two metal probes touch your finger
-If the water leakage alarm emits a flashing red light and a loud alarm sound, it can work normally
8. Frequently seen questions:
-The water leakage alarm will give an alarm when there is no water leakage. It may be caused by the water leakage alarm being placed on the metal conductor, which will cause the trigger. Please put a piece of paper under the water leakage alarm
-In case of water leakage, the water leakage alarm does not sound an alarm.
One reason is that the placement method of the water leak alarm is incorrect. The correct method is to lay the water leak alarm flat on the place where the water leak may occur, with the buzzer hole facing upward. The detection head is facing down, so that the sensor of the alarm (that is, the two touching the metal) can easily contact the water. Another reason is that the battery voltage is too low, which prevents it from working and should be replaced with a new battery.