Speed Measuring Sensor Module
New
Indicative market price: R49.64
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Free collection from
Henley on Klip, Meyerton
The seller allows collection for this item and will be in contact with the full collection address once the order is ready.
Ready for collection by Wednesday, 15 May.
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
1104
Bob Shop ID
613701802
Uses improved groove optical coupling sensor, width 5mm. Has an output state light, if output level is high, the lights are off. If output is low,light is on. If the sensor is covered, it will output a high level.
Features
Wiring specifications
VCC Connect positive 3.3 to 5V power supply
GND Connect power negative
DO TTL switch signal output
AO Not used
What's in the box?
1 x Speed Measuring Sensor Module
Shipping notes
As from 18/11/2023 this product will include four 10cm female to female jumper cables. Colours will vary.
Resources
Features
- Uses improved groove optical coupling sensor, width 5mm.
- It has an output state light, if output level is high, the lights are off. If output is low,light is on.
- If sensor is covered,it will output a high level.
- Working voltage of 3.3V to 5V.
- Output: digital switch output (0 and 1).
- Equipped with a fixed bolt hole, easily install.
- Small board PCB size: 32 mm x 14 mm.
- Use the LM393 wide voltage comparer.
Wiring specifications
VCC Connect positive 3.3 to 5V power supply
GND Connect power negative
DO TTL switch signal output
AO Not used
What's in the box?
1 x Speed Measuring Sensor Module
Shipping notes
As from 18/11/2023 this product will include four 10cm female to female jumper cables. Colours will vary.
Resources
GETTING STARTED WITH ENCODER SENSOR MODULE (SN-ENC-MOD)
Note: Stock is currently available in South Africa for national shipping!