Name: Step Down Buck Converter Charger 15W LM2596 3A **LOCAL STOCK**
SKU: STE335
Price: 49.00 ZAR
Availability: SoldOut

Step Down Buck Converter Charger 15W LM2596 3A **LOCAL STOCK**

New

24 were available

R49.00

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Led Select - Cape Town29868

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Product code

STE335

Bob Shop ID

420235561

Step Down Voltage + Current 15W 3A:

Category: 3200312645 / 3204312645 - Step Up Down / Voltage Regulator

Specifications:

Input Voltage: 5-35V
Output Voltage: Continuously adjustable from 1.25 V to 30V
Rated Output Current: 3A Max
Size: 48 x 24 x13mm
Indicator Light:
Constant current indicator (red)
Charging indicator (red)
Charged full (green)

Battery use:

Make sure of the voltage and current of the battery you need to charge
Adjust the constant voltage potentiometer to make the output voltage same to the charge voltage
Potentiometer Adjustment Direction: Clockwise (increase), counterclockwise (decrease)
Use the multimeter in 10A current scale to measure output short-circuit current, and adjust the current potentiometer to make sure the output current to the expected charging current value
Connect to the battery and try to charging (for previous 4 steps, module input terminal is connected to power source, output load is NOT connected to batteries)

LED Constant Current Driver Use:

Make sure operating current and Max operating Voltage of the LED you need to drive
Adjust the constant voltage potentiometer to make sure the output Voltage is up to LED Max operating Voltage
Use the multimeter in 10A current scale to measure output short-circuit current, and adjust the current potentiometer
Set the output current to the expected LED operating current
Join LED, test (For the above 3 steps, module input terminal is connected to power source, output load is NOT connected to LED)

* If the Output current is greater than 2.5A (or output power greater than 10W) to work long hours, please add 14x14x5mm heat sink to IC Chip