Stepper Motor Interface Mach3 5 Axis Usb Interface Breakout Board
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
613430260
1. Fully support for MACH3 and other computer software that supports parallel port control. USB power supply and peripheral power supply are separated to ensure computer security.2. 12-24V wide peripheral voltage input, with anti-reverse connection function. All input signals are isolated by optical coupling, and can be connected to emergency stop, tool setting, limit, etc.3. One-way relay output port can control the spindle switch. The output port is P17 port. One-way optocoupler isolated 0-10V analog voltage output can control the inverter with the corresponding analog interface to control the spindle speed. The output port is the P1 port.4. Open all 17 ports, can be connected with optocoupler drive, can control 5-axis stepper motor. P1 acts as a PWM output and can control the spindle governor with optocoupler input.5. Can be connected to the common cathode/anode drive with input level of 5V.Input voltage range: 12-24VDCMaterial: PCBcolour: greenPackage Contents:1 x Stepper Motor Interface Board1 x USB Cable1 x Parallel Port CableOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.