R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable. Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Replacement Guarantee:7 Days: We stand by this guarantee
Product information
Condition:
New
Location:
International
Bob Shop ID:
613471533
Input voltage: 5V-24V; Dimensions: 6.30 in x 2.95 in x 0.91 in (16.0 cm x 7.5 cm x 2.3 cm); Weight: 230 gNumber of programs: 16 MAX; MAX number of pixels: 2048; Compatible with single line or double line chips.32-256 Gray, Support software Gamma correction. Support the rules and special-shaped handle. Single-port output, can support 2048 lights.Off-line(SD Card) control, play back content stored in the SD card. T-1000S store a maximum of 16 programs, copy multiple files to the SD card in order after formatting the SD card as FAT format.The program must be named in orders . Ex. : 00_1.led, 01_1.led, 02_1.led.NOTE: for the TTL(SPI) signal, the controller signal ground must connect to the LED ground directly.Mode of connection1.Multiple T-1000S controllers can be cascaded together and work synchronous.2.T-1000S one TTL(SPI) signal and one RS485 signal port output,can control 2048 pixels3.When the chip for LED is single line chip just with data, then just need to be connected with DAT and GND of the controller. If the chip for LED is double line chip with DAT and CLK, then need to be connected with DAT, CLK, and GND of the controller.4.If you need to use RS485 signal you need to connect controller A with LED A (DMX+), controller B with LED B(DMX-)color:As shownMaterial:plasticPackage Contents:1 x T-1000S RGB LED Pixel controller1 x SD CardOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.