Tork Craft Compounding & Polishing Sponge 150Mm X M14 Premium White - DEFAULT TITLE

Tork Craft Compounding &Amp; Polishing Sponge 150Mm X M14 Premium White

Pattern: Standard
Density: Firm
Colour: White
Diameter: Ø150Mm
Thread/Velcro: M14

 Application:

The Compounding Sponge Should Be Used With An Automotive Polisher.

It Is Necessary To Polish A Vehicle Body Panel When:

• The Panel Has Been Newly Painted With A Clear-Coat.
• Shallow Scratch Marks Need To Be Removed.
• The Panel Has Suffered From Oxidation.
• Swirl Marks And Hologram Defects Need To Be Removed.

Steps To Take When Polishing A Panel:

1. Preparing The Panel:

• Sometimes A Panel Has Fine Over-Spray Left From Spraying The Clear-Coat. This Needs To Be Removed By Lightly Sanding With A Fine Abrasive Paper. All Over-Spray Need To Be Sanded Out Up To P1500 Grit.
• The Panel Should Be Washed When All Spray-Finishing Defects Have Been Removed. Any Dirt Particles Could Cause Scratch Marks When Polishing.
• Tight Curves And Ends Of The Panel Should Be Masked-Off To Prevent The Effects Caused By Point Pressure. The Polisher Should Always Be Used On Flat Surfaces.

2. Applying The Polishing Compound:

• A Five Rand Coin Amount Of Polishing Compound Should Be Applied To The Sponge. Switch The Polisher To It'S Lowest Speed Setting.
• Switch On The Polisher And Gradually Spread The Polishing Compound Over The Panel.
• Keep Moving The Polisher On The Panel To Have As Little Amount Of Pressure And Friction.
• The Polishing Compound Will Remove The Scratch Marks Caused By The P1500 Sand Paper And It Will Bring Out An Impressive Gloss Finish.
• Remove The Masking From The Panels And Apply The Polishing Compound To A Microfiber Cloth. Hand Polish (By Moving Your Hand In A Small Circular Motion) The Tight Curves And Ends In The Panels Until The Same Finish Is Achieved As From The Polisher.

3. Wash The Panel When Finished:

• Wash The Panel After Polishing To Remove Any Residue From The Polishing Compound.