Tork Craft Double Sided Wool Buff 7' 180Mm With 5/8 Thread

Diameter: Ø180mm
Thread/Hook & Loop: 5/8 UNC

 Application:

The double sided wool buff should be used with an automotive polisher.
Different compounds, polishes and waxes can be applied to both sides of the buff
and then flipped around when needed. This saves time without the need of
changing to another buff.

It is necessary to polish a vehicle body panel when:

• The panel has been newly painted with a clear-coat.
• Shallow scratch marks need to be removed.
• The panel has suffered from oxidation.
• Swirl marks and hologram defects need to be removed.

TIP:
The buff is washable after use if the compound is soluble.

Double sided wool buff range:

Adaptors to convert or lenghten the polisher's thread:

Steps to take when polishing a panel:

1. Preparing the panel:

• Sometimes a panel has fine over-spray left from spraying the clear-coat.
  This needs to be removed by lightly sanding with a fine abrasive paper. All
  over-spray need to be sanded out up to P1500 grit.
• The panel should be washed when all spray-finishing defects have been
  removed. Any dirt particles could cause scratch marks when polishing.
• Tight curves and ends of the panel should be masked-off to prevent the
  effects caused by point pressure. The polisher should always be used on flat
  surfaces.

2. Applying the polishing compound:

• A five rand coin amount of polishing compound should be applied to the
  sponge. Switch the polisher to it's lowest speed setting.
• Switch on the polisher and gradually spread the polishing compound over
  the panel.
• Keep moving the polisher on the panel to have as little amount of
  pressure and friction.
• The polishing compound will remove the scratch marks caused by the P1500
  sand paper and it will bring out an impressive gloss finish.
• Remove the masking from the panels and apply the polishing compound to a
  microfiber cloth. Hand polish (by moving your hand in a small circular
  motion) the tight curves and ends in the panels until the same finish is
  achieved as from the polisher.

3. Wash the panel when finished:

• Wash the panel after polishing to remove any residue from the polishing
  compound.

consider safety for your health and the people around you
General safety suggestions: It is advisable to always have the following items nearby and in a good condition Eye protection clean and scratch free Hearing protection quality earmuffs Dust masks discard old and dirty masks Gloves for easy handling of material and hand protection
Wear Gloves	Eye Protection	Hearing Protection	Dust Mask