Tork Craft Polisher 1200W With 180Mm Wool Bonnet And 4M Cord
6 Months Warranty Included
Supplied With A 180Mm Wool Bonnet Buff And Backing Pad.
Application:
The Polisher Is A Power Tool Used In The Finishing Process, Used With Polishing Buffs And Compound Sponges To Yield A Dramatic Difference On A Painted Surface.
The Objective Of Polishing Is To Remove Imperfections In The Clear-Coat That Cause The Paint To Look Dull. Surface Imperfections Can Include Swirls, Scratches, Water Spots, Etchings, Industrial Fallout, Oxidation, Etc.
Features:
- Professionally Manufactured For The Automotive Paint Care And Detailing Industries.
- Ergonomically Designed To Reduce Fatigue In Long Term Use.
- The Polisher Has Various Hand-Held Positions To Better Hold The Polisher At Angles.
- Gear System Has A Two-Level Deduction. With Two Times The Amount Of Torque Than A Single Gear Set Polisher
Extra Information:
Steps To Take When Polishing A Panel:
1. Preparing The Panel:
- Sometimes A Panel Has Fine Over-Spray Left From Spraying The Clear-Coat. This Needs To Be Removed By Lightly Sanding With A Fine Abrasive Paper. All Over-Spray Need To Be Sanded Out Up To P1500 Grit.
- The Panel Should Be Washed When All Spray-Finishing Defects Have Been Removed. Any Dirt Particles Could Cause Scratch Marks When Polishing.
- Tight Curves And Ends Of The Panel Should Be Masked-Off To Prevent The Effects Caused By Point Pressure. The Polisher Should Always Be Used On Flat Surfaces.
2. Applying The Polishing Compound:
- A Five Rand Coin Amount Of Polishing Compound Should Be Applied To The Buff. Switch The Polisher To It'S Lowest Speed Setting.
- Switch On The Polisher And Gradually Spread The Polishing Compound Over The Panel.
- Keep Moving The Polisher On The Panel To Have As Little Amount Of Pressure And Friction.
- The Polishing Compound Will Remove The Scratch Marks Caused By The P1500 Sand Paper And It Will Bring Out An Impressive Gloss Finish.
- Remove The Masking From The Panels And Apply The Polishing Compound To A Microfiber Cloth. Hand Polish (By Moving Your Hand In A Small Circular Motion) The Tight Curves And Ends In The Panels Until The Same Finish Is Achieved As From The Polisher.
3. Wash The Panel When Finished:
- Wash The Panel After Polishing To Remove Any Residue From The Polishing Compound.
General Safety Suggestions:
It Is Advisable To Always Have The Following Items Nearby And In A Good Condition
- Eye Protection " Clean And Scratch Free
- Hearing Protection " Quality Earmuffs
- Dust Masks " Discard Old And Dirty Masks
- Gloves " For Easy Handling Of Material And Hand Protection
