Tork Craft Polisher Service Kit Speed Control (38) For Pol06

Tork Craft Polisher Service Kit Speed Control (38) For POL06

At a Glance: Genuine speed control service kit for the Tork Craft POL06 polisher

The Tork Craft polisher service kit speed control (Cat No. POL06-SK12) is a genuine replacement electronic module designed specifically for the
Tork Craft POL06 polisher. The speed controller regulates the motor speed so you can match the polishing action to the job â" slow and controlled
for delicate surfaces, faster for more aggressive cutting. When this module fails, the polisher may lose variable speed, surge, run at one fixed
speed or stop working altogether. Replacing it with this original POL06-SK12 service kit restores smooth, repeatable speed control and gives new
life to a POL06 that still has a sound motor and gearbox.

Specifications

Features

• Genuine Tork Craft service kit Original speed control module for the Tork Craft POL06 polisher (position 38).
• Electronic speed regulation Designed to keep pad speed stable and controllable under varying loads.
• Direct-fit assembly Connectors and mounting layout match the existing POL06 wiring and housing.
• Compact design Fits neatly in the control cavity without modification to the body or handle.

Benefits

• Restore Variable Speed: Brings back smooth, adjustable speed control when the original module has failed.
• Improved Finish Quality: Being able to slow down or speed up the polisher helps reduce swirl marks and burning.
• Consistent Performance: Electronic regulation keeps the pad speed more stable as pressure and load change.
• Cost-Effective Repair: Rescues a good POL06 polisher by replacing only the faulty speed controller.

Extra Information

• Intended as the speed control service kit for position 38 on the Tork Craft POL06 polisher spare parts diagram.
• Recommended when the polisher loses variable speed, runs erratically, only works at one speed or fails to start due to a control fault.
• Ideal for workshops and service centres refurbishing POL06 polishers that are still mechanically sound.

Safety

• Always disconnect the polisher from the power supply before opening the housing or working on electrical components.
• Only suitably competent persons should carry out electrical repairs; consult an authorised service centre if unsure.
• After fitting the new controller, check that all wiring is secure, correctly insulated and clear of moving parts before closing the housing.
• Test the polisher at no-load speed and cycle through the speed range to confirm correct operation before returning it to service.