This item has closed 1 buyer bought 1 item

Similar products

Tork Craft Polishing And Compound Kit
Sold

Tork Craft Polishing And Compound Kit

New 1561 were available
Indicative market price: R240.00
R187.00
22% off
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Returns
Warranty Type: Manufacturer "This product comes with a full manufacturers warranty"
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
VER/TC804901
Bob Shop ID
252719994
Polishing and compound kit

Application:

The kit includes a polishing buff and 5 solid polishing compounds. The compounds are used with various metals. It can be used to remove stretcher strains, orange peel, polishing wheel grit lines and light die marks etc.

TIP:
Spare polishing compound is available for the kit:

  • It would be best to use a drill press to polish metals. If a drill press is not accessable, use adaptor TCV01810 with a portable drill with a collar diameter of Ø43mm. Tighten the adaptor in the drill's chuck.
  • The buffing pad should revolve towards you at full speed. Pass the compound lightly across the face of the buffing pad. To ensure that the compound is evenly spread, hold a clean piece of scrap metal against the face of the buffing pad. This will eliminate lumps of compound from occuring.
  • If desired, heat the item to 65°C using an oven or a heater. Warming the metal keeps the compound on the buffing pad. A cool item will draw compound from the pad and leave deposits. Use a glove to handle the warm item.
  • Hold the metal lightly against the buffing pad. Allow the compound to do the work.
  • If more compound is required, apply it using a wiping motion. Do not overload the buffing pad.