This item has closed 1 buyer bought 1 item
Tork Craft Scroll Saw Blade 25tpi W/Pins 6/Pack
New
R132.00
Closed
12 Jan 22 01:29
TechnoPro(Blacklisted)
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
South Africa
Customer ratings:
Product code:
VER/SSB42701
Bob Shop ID:
536342849
Scroll saw blades pinned
Pinned blades 127mm (5') for a scroll saw.
LENGTH: 127mm (5') between pins
TPI: 25
PINS: Yes
Application:
The blades are manufactured to be used with
scroll saws.
There are various blade types available in the range with different teeth styles for different uses.
A minimum pilot hole of 4.7mm is required for cut-outs. Take a look at the chart below to select the correct blade for the recommended material and thickness.
Scroll saw blade selection chart:
| CODE | TPI | TOOTH | APPLICATION + MAX. MATERIAL THICKNESS |
| 42401 | 18.5 | Skip tooth | Very thin cuts in hard and soft woods. 19mm |
| 40501 | 20 | Regular | Thin cuts in hard and soft woods. 19mm |
| 41001 | 7 | Hook | Cut thick hard and soft woods. 51mm |
| 41101 | 15 | Regular | General purpose blade for woods & plastic. 19mm |
| 41201 | 10 | Regular | Fast cutting of hard and soft woods. 19mm |
| 42003 | 9/5 | Skip tooth | Fast cut blade with reversed teeth for woods. 19mm |
| 42701 | 25 | Regular | Fine cuts in aluminium, plastic, soft woods & veneer to 19mm |
DEFINITION:
TPI - Teeth per inch. The amount of teeth measured between 25.4mm
Note:
Some blades have reversed teeth for fast paced cutting. Take care when using these blades as the blades can lift up your project from the scroll saw table when cutting.