Tork Craft Vernier 150Mm Plastic Metric 0.05 Acc
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 7 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
ME17150
Bob Shop ID
607210833
Tork Craft Vernier 150Mm Plastic Metric 0.05 Acc
Tork Craft, the name everybody knows. Quality tools and accessories for every job. Every new Tork Craft product goes through our Product Testing department for quality approval. Browse the Tork Craft website to experience the extensive catalogue.
Torkcraft - Plastic Analog Vernier Caliper
Range: 0-150Mm & 0-6'
Accuracy: 0.05Mm & 1/128'
Material: Plastic
Readout: Analog
&Nbsp;
&Nbsp; Application:
The Vernier Caliper Is Used To Give A Direct Reading Of The Distance Measured With High Accuracy And Precision.
There Are Two Different Vernier Calipers Available In The Tork Craft Range:
- Analog Vernier Calipers.
- Digital Vernier Calipers.
Using An Analog Vernier Caliper:
- To Measure Outer Dimensions Of An Item, The Item Is Placed Within The External Jaws, Which Are Then Moved Together Until Against The Object.
- To Measure Inner Dimensions Of An Item, The Internal Jaws Are Placed Within The Opening, Which Are Then Spread Open Until Against The Object.
- To Measure The Depth Of An Opening, The Depth Rod Is Placed In The Opening, Which Are Then Slid Down Until It Touches The Bottom Of The Opening.
- Read The Main Scale Where It Lines Up With The Sliding Scale'S Zero. The Main Scale On A Vernier Calliper Typically Tells You The Whole Number Plus The First Decimal.
- Read This Just As You Would A Ruler, Measuring To The Zero Mark On The Sliding (Vernier) Scale.
- The Digits Remaining Are Taken From The Vernier Scale And Placed After The Decimal Point Of The Basic Reading. This Remaining Reading Corresponds To The Mark That Is Lined Up With Any Main Scale Mark (Or Division).
- Only One Division Line Of The Vernier Scale Should Match With One On The Main Scale.
Safety Tips:
- Make Sure The Workpiece Being Measured Is Clean And Has No Burrs On The Edges.
- When Measuring A Workpiece In A Lathe, Ensure That It Is Switched Off
- Keep Precision Measuring Tools Away From Magnetic Objects
Brand :Tork Craft
SKU :ME17150
Barcode :6009515878610