Name: Touch Sensor (Arduino Compatible)
Brand: Arduino
SKU: SEN-00146
Price: 34.50 ZAR
Availability: InStock

Touch Sensor (Arduino Compatible)

5 available / new

Only 5 left – grab it before it’s gone!

R34.50

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Netram Technologies663

98.56 % Positive ratings

Get it now, pay later

Condition

New

Location

South Africa

Brand

Arduino

Product code

SEN-00146

Bob Shop ID

640040096

This Touch Sensor is Capacitive Touch based on touch detection IC (TTP223B). It is Arduino Compatible and has the low power consumption power mode. When it is touched by a finger, the module will output high power and is switched to fast mode. If the sensor is not being used for 12 seconds, it switches to low power mode. The module can be installed in enclosures such as plastic, glass surface and non-metallic materials (in addition to a thin piece of paper (non-metallic) covering the surface of the module, as long as the touch of the correct position). You can even hide it in a wall of a building, desk and other places instead of using a visible button.

Specifications:

Project	Min	Typical values	Max	Unit
Power supply voltage VCC	2.0	3	5.5	V
Output high level VOH	-	0.8VCC	-	V
Output Low VOL	-	-	0.3VCC	V
Output pin sink current (@ VCC = 3V, VOL = 0.6V)	-	8	-	mA
Output pin pull-up current (@ VCC = 3V, VOH = 2.4V)	-	-4	-	mA
Response time (low power mode)	-	-	220	mS
Response Time (Fast mode)	--	--	60	mS
Size		24X24X7.2		mm
Weight		2		g

Control Interface:

A total of three pins (GND, VCC, SIG)

GND is ground
VCC is the power supply
SIG is a digital signal output pin

Power Indicator:

Green LED indicates Power is On

Touch area:

Similar fingerprint icon interior region can be triggered by finger touch.

Positioning holes:

4 x M2 screw positioning holes with a diameter of 2.2mm

Report a problem

Touch Sensor (Arduino Compatible)

Product details

Recently viewed

Similar products

Touch Sensor (Arduino Compatible)

Product details

0.0 out of 5

Recently viewed

Similar products