Ultrasonic Series Display Board

Ultrasonic Series Display Board

New 3 available
Indicative market price: R190.00
Only 3 left – grab it before it’s gone!
R172.73
Shipping
R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Seller
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Product code
2634
Bob Shop ID
619680841

This module adopts an 8-bit MCU as the main control chip, it can be applied in distance measurement, testing the performance of the HC-SR04 ultrasonic module. Plus, you can use this module in two ways since it supports Serial Port Display and Digital Tube Display.

 

Specifications

  • Integrated STM8S103 High-Performance Microprocessor
  • Interfaces:
    • Digital Tube Display
    • Serial Port Data Output
  • Input Voltage: 5V
  • LiPo Connector: 2.54mm socket (5V power supply)
  • Measuring Distance: 3cm - 400cm
  • Plate Size: 25mm x 35mm
  • Weight: 7g

 

What's in the box?

1 x SR04 Ultrasonic Series Display Board
Resources

How To Use

Measured distance can be displayed via the digital tube or serial port:

  • Digital Display: directly connect ultrasonic sensor and provide 5V power supply (using wire jumpers or LiPo battery).
  • Serial Port Output: connect the display module pins (VCC, TX, RX, GND) to USB to TTL converter pins (5V, RX, TX, GND) respectively. Select 9600 baud transmission rate and the output format is "D: XXX", where XXX represents the distance in centimeters.



Note: No code is required to use this module! Plug and play, very easy to use for beginners.

 

Additional Notes

  • When measuring the distance, the area of the measured object should not be less than 0.5 square meters, and it should be smooth and have strong reflectivity. Failure to do so will affect the test result.

  • Valid measuring distance: 3-400cm. If it is longer than this range, it will result in incorrect data or shows a 000 screen.

 

Note: Stock is currently available in South Africa for national shipping!
Add to cart

Recently viewed

See more
Drawing and Perceiving: Life Drawing for Students of Architecture and Design
Secondhand
R350.00
Bangles - The Bangles Collection (CD, Comp)
Refurbished
R234.00
Waterproof Temperature Sensor (DS18B20) - 1 METER
New
R68.77
PS5 Dualsense Controller Matte UV ABXY Buttons
New
R197.40

Similar products

SSY Components + PCB Board Digital Tube Display FM Digital Radio Electronic DIY Production kit
New
R511.00
9% OFF
LCD Board 2004 20x4 5V Blue screen display with controller
New
R159.65 R175.62
70% OFF
Kwikboil PC Board
Secondhand
R300.00 R995.00
AVR ATMEGA16 Minimum System Board ATmega32 Development Board for ISP ATTiny 51 Board
New
R317.00