R35.00 shipping Buyer protection programme Stores Help 010 005 6200

Unify Pro and Rx mounting board - 5V and HV/Race versions

Name: Unify Pro and Rx mounting board - 5V and HV/Race versions
SKU: 754578
Price: 86.25 ZAR
Availability: InStock

New

17 available

Type

HV/RACE

HV V3

R86.25

Add to watchlist Watch

Shipping

R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

FlyingRobot440

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Product details

Condition

New

Location

South Africa

Product code

754578

Bob Shop ID

593522070

This board allows a TBS Unify Pro (5V or HV/Race) and receiver to be mounted in a stack for a low profile and clean solution. The pads let you to solder your Unify to the mounting board. You can either use the plug that comes with the Unify or directly solder the wires to the pads.

There is the option to easily solder a FrSky D4R, X4R, or XM+ receiver, but you are not limited to only those receivers. Spektrum, Futaba, FlySky, or any other receivers are also compatible. Simply connect the Rx directly to the flight controller (ignore the receiver portion on the board) or connect the Rx to one of the header pins on the Unify Mounting Board and use the pads located on the side as intended. The solder bridge pads will still have to be used to select which headers you will be using.

Report a problem