USB 2.0 Diagnostic Cable KKL VAG-COM for VW / Audi 409.1
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Product information
Condition:
New
Location:
International
Product code:
S-CMS-0936R
Bob Shop ID:
596638452
1. This diagnostic cable is usable for ISO9141 and KWP2000 transmission protocol like used for example by:
- For Volkswagen
- For Audi
- For Skoda
- For Seat
2. This cable cannot work if your car uses a protocol/bus system like VPW, PWM or CAN-bus.
3. Terminal K = Bus of communication
4. Terminal L = Ignition for waking up car computing system (ECU: Engine Control Unit)
5. Existed 3 different protocols with same OBD2 connector incl. ISO/KWP, VPW, PMW
6. This K/L Diagnostic interface & cables work on ISO/KWP (Key Word Protocol) launched after 1996 only.
7. Supported also ISO9141 protocol
8. The Cables may work with some versions of the Car soft, but car soft used a lot of different interfaces during the different versions and also had some custom interfaces.
- For Volkswagen
- For Audi
- For Skoda
- For Seat
2. This cable cannot work if your car uses a protocol/bus system like VPW, PWM or CAN-bus.
3. Terminal K = Bus of communication
4. Terminal L = Ignition for waking up car computing system (ECU: Engine Control Unit)
5. Existed 3 different protocols with same OBD2 connector incl. ISO/KWP, VPW, PMW
6. This K/L Diagnostic interface & cables work on ISO/KWP (Key Word Protocol) launched after 1996 only.
7. Supported also ISO9141 protocol
8. The Cables may work with some versions of the Car soft, but car soft used a lot of different interfaces during the different versions and also had some custom interfaces.