USBASP AVR ISP Programmer - USB Downloader for ATmega and ATtiny
Check my rate
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
USBASP in-system programmer for Atmel AVR and 51-series microcontrollers. It connects directly to a computer USB port and programs the target chip in circuit through the ISP header, so the microcontroller stays on the development board or breadboard.
Interface and power
- USB connection to the host computer, no separate supply needed
- USB powered, with the option to draw target power from the board
- Target voltage selectable at 5V or 3.3V via jumper
- Over-current protection on the output
- LED indicators for power and programming activity
Supported devices
- AVR series, including ATtiny12/13/15/24/25/26/44/45/84/85/2313 and ATmega8/16/32/48/88/162/164/165/328/8515/8535
- AT90S series, including AT90S1200/2313/2323/2343/8515/8535
- 51 series: AT89S51, AT89S52, AT89S53, AT89S8252
Connections
- 10-pin ISP header in the Atmel standard pinout
- Supplied ribbon cable for connecting to the target board
- A 6-pin adapter or cable modification is needed for boards with the 6-pin AVR header
- Programming interface reserved for updating the programmer firmware
Software and systems
- Works with AVRDude and with AVR_fighter and PROGISP 1.66 to 1.68
- Windows XP, 7, 8 and 8.1, 32-bit and 64-bit
- Also used under Linux and macOS
What is included
- USBASP programmer board
- USB cable
- 10-pin ISP ribbon cable
Notes
- The board is an open-source design; drivers are available from the project page
- Check that your target board uses the 10-pin or 6-pin ISP layout before connecting