Vdiagtool OT100 Car Oil Tester
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
CRP1539
Bob Shop ID
593704304
1. This device provides a reference for judging whether the brake fluid is still usable or needs to be replaced.It mainly used for detecting the quality of the brake fluid, so as to ensure that the brakes are sensitive and drive safety.
2. LCD display the test result to tell you the quality of brake fluid.
3. Long probe designed for Motor vehicle,no need to take oil outside.
4. Wide range test to support DOT3, DOT4, DOT5.1 different brake fluid.
5. Using Instruction
(1). Open the hood and find the dipstick.
(2). Press the power button to turn on the turbine oil detector.
(3). Pull out the engine dipstick and put the probe into the dipstick hole.
(4). Click the button switches to turbine oil detection status.
(5). Wait for 10 seconds for to show the test results,click the the button to clear the measurement results.
2. LCD display the test result to tell you the quality of brake fluid.
3. Long probe designed for Motor vehicle,no need to take oil outside.
4. Wide range test to support DOT3, DOT4, DOT5.1 different brake fluid.
5. Using Instruction
(1). Open the hood and find the dipstick.
(2). Press the power button to turn on the turbine oil detector.
(3). Pull out the engine dipstick and put the probe into the dipstick hole.
(4). Click the button switches to turbine oil detection status.
(5). Wait for 10 seconds for to show the test results,click the the button to clear the measurement results.