Vernier digital frac. 300mm s/steel 0.01mm acc. abs func. ip54
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
ME12300
Bob Shop ID
616067079
Digital vernier caliper
Measuring length: 300mm
Readout: Digital (fractional)
Material: Stainless steel
Accuracy: 0.01mm
Application:
The vernier caliper is used to give a direct reading of the distance measured with high accuracy and precision.
There are two different vernier calipers available in the Tork Craft range:
- Analog vernier calipers.
- Digital vernier calipers.
Before using a vernier caliper:
- Make sure the workpiece being measuring is clean and has no burrs on the edges.
- Make sure the lathe is switched off when measuring a workpiece in a lathe.
- The temperature of the workpiece is required to be around 20C to have consistent measuring results.
- Precision measuring tools should never be put near a magnetic area to avoid the vernier caliper being magnetized.