Name: Voltmeter / Ammeter DC 0.00-33.0V/10A Dual LED Display (Red+Yellow) **IN STOCK**
SKU: MET142
Price: 109.00 ZAR
Availability: SoldOut
Rating: 5 (2 reviews)

Voltmeter / Ammeter DC 0.00-33.0V/10A Dual LED Display (Red+Yellow) **IN STOCK**

3 were available / new

R109.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller allows collection for this item. Buyers will receive the collection address and time once the order is ready.

The seller has indicated that they will usually have this item ready to ship within 2 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Led Select - Cape Town29868

100.00 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

South Africa

Customer ratings:

2 ratings

Product code

MET142

Bob Shop ID

352885214

Voltmeter / Ammeter DC 0.00-33.0V/10A Dual LED Display (Red+Yellow):

Specifications:

Display Colour: Red+Yellow
Display Mode: Dual 0.28 LED Digital Tube
Update Rate: About 500 ms/time
Physical Size: 48 x 29 x 26 mm (L * W * H)
Opening Size: 45 x 26 mm (L * W)
Supply Voltage: 3.5-30V
Lead Wire Length: 14 cm (Five wires)
Measurement Range: DC 0.00-9.99A (current) 0.00-33.0V(voltage)
Operation Temperature: -10 Degrees~65 Degrees
Measurement Accuracy: ± (1% + 2 digits)

Instruction of Wiring:

Red thin wire (VCC): Power input+ 3.5-30V (NOTE: If the measuring signal is lower than 30V and have abundant power supply, it can be used as power supply for the module [black wire and yellow wire are contacted together to use]

Black thin wire(GND): Power input- Measurement signal - 3.5-30V

Yellow thin wire (VIN): Measurement signal+ (0-33.0V)

Red thick wire (I+): Current input+ (connect with load negative)

Black thin wire(I-): Current input- (in series in power supply negative)

Voltage current meter with isolated power supply:

Instruction:

To Calibrate the meter to zero, when the meter is off the power, please connect A and B. Then give the meter power, the meter will automatically be calibrated to zero. When the automatic calibration is over, please disconnect A and B.