This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1742
Similar products
W2310 10A 12V 24V 220VAC Digital LED Temperature Controller for Incubator Thermo... (VOLTAGE: DC12V)
New
R412.00
Closed
11 May 24 00:05
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
612373620
SELECTED OPTION:
VOLTAGE: DC12V
1. Convenient direct output wiring 2. Add buzzer and audible alarm 3. Add pause button to stop urgently 4. Ring waterproof sensor, easy to fix 5. Start and stop setting mode, provincial conversion, which is more convenient 6. Automatically save when power off, run automatically when power on 7. Both Fahrenheit and Fahrenheit can be measured (need to switch mode) ? Specification:
Controller type : Normally open temperature controller Operating Voltage : DC12V DC24V AC110~220V Control circuit voltage? : DC12V DC24V AC110~220V Relay carrying power :? 240W 480W 10A???max??? Recommended power? : ???Relay carrying power??80% Relay type : Normally open relay Power consumption : ???1W Relay service life : 100000 Times sensor :? NTC10K? 1% Range :? -50a??~120a?????±1%??? Size? : 67mm??45mm??34mm Fixed way : Embedded? Hole 63mm??42mm
Operation demonstration:
1. Application example: Heating method for hatching poultry eggs 2.Incubation conditions: The optimum temperature is 38.6a??, and the allowable temperature is 0.2a??, then the incubation temperature range is 38.4a??-38.8a?? 3. Assumptions: It is assumed that the incubation equipment has been connected, but it is? found that the measured temperature is 0.5a?? higher than the actual temperature 4. Operation introduction: A: Press the SET button (10 seconds) on the conventional interface to enter the setting mode, the red digital tube displays the code, the blue digital tube displays the code parameter value; press? SET key to? ?switch the code, press up/down key Modify parameter value B: Adjust the value of P0 to 38.4 and the value of P1 to 38.8 C: Adjust P4 to -0.5 D: After the code setting is completed, wait for 10 seconds to automatically save, the setting is completed
Note: All settings are automatically saved when power is turned off, run automatically when power is turned on, and no manual start is required Press and hold the SET key to power on to recover the factory settings, please refer to the manual for detailed parameters
Package included:
1 x W2310 Normally Open Temperature Controller
