Waveshare 2.13 Inch E-ink Screen Display e-Paper Module SPI Interface Partial Refresh Black Yellow
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615100109
Documents:
Introduction:
Note: The raw panel require a driver board, If you are the first time use this e-Paper, we recommend you to buy the HAT version or buy more one driver hat for easy use, otherwise you need to make the driver board yourself. And this instruction is based on the version with PCB or driver board.
Features:
No backlight, keeps displaying last content for a long time even when power down Ultra low power consumption, basically power is only required for refreshing
Specifications:
Operating voltage: 3.3V Interface: 3-wire SPI, 4-wire SPI Outline dimension: 29.2mm ?? 59.2mm ?? 0.98mm Display size: 23.71mm ?? 48.55mm Dot pitch: 0.229 ?? 0.228 Resolution: 212 ?? 104 Display color: yellow, black, white Grey level: 2 Full refresh time: 15s Refresh power: 26.4mW(typ.) Standby power: <0.017mW Viewing angle: >170?ﾣ
Interfaces:
Package includes:
1 x Bareboard
Introduction:
Note: The raw panel require a driver board, If you are the first time use this e-Paper, we recommend you to buy the HAT version or buy more one driver hat for easy use, otherwise you need to make the driver board yourself. And this instruction is based on the version with PCB or driver board.
Features:
No backlight, keeps displaying last content for a long time even when power down Ultra low power consumption, basically power is only required for refreshing
Specifications:
Operating voltage: 3.3V Interface: 3-wire SPI, 4-wire SPI Outline dimension: 29.2mm ?? 59.2mm ?? 0.98mm Display size: 23.71mm ?? 48.55mm Dot pitch: 0.229 ?? 0.228 Resolution: 212 ?? 104 Display color: yellow, black, white Grey level: 2 Full refresh time: 15s Refresh power: 26.4mW(typ.) Standby power: <0.017mW Viewing angle: >170?ﾣ
Interfaces:
| VCC | 3.3V |
| GND | GND |
| DIN | SPI MOSI |
| CLK | SPI SCK |
| CS | SPI chip select (Low active) |
| DC | Data/Command control pin (High for data, and low for command) |
| RST | External reset pin (Low for reset) |
| BUSY | Busy state output pin (Low for busy) |
Package includes:
1 x Bareboard
