Waveshare 2.8 inch Touch Screen Expansion Fully Laminated Display For Raspberry Pi CM4
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
DIY0239
Bob Shop ID
593704926
1. Touch screen expansion board + interface expander: The touch screen expansion board and an additional interface expander, with Gigabit Ethernet port, M.2 slot for connecting communication module or SSD, and more USB ports.
2. 2.8 inch display with 5-point capacitive touch control, better touch experience from the fully laminated screen, together with 6H toughened glass panel, more safe to use
3. Touch Screen Expansion Board Introduction:
- CM4 socket: Suitable for all variants of Compute Module 4
- USB: USB 2.0 x 1
- Connector: MIPI CSI 22PIN 0.5mm camera connector
- Display: 2.8 inch fully laminated screen, 480 x 640 pixels, 5-point capacitive touch, toughened glass panel
- Video: Micro HDMI x 1, supports 4K 30fps output
- Storage: MicroSD card socket for Compute Module 4 Lite (without eMMC) variants
- Power input: 5V
4. Interface Expander Introduction
- Networking: Gigabit Ethernet RJ45; M.2 M KEY, support NVME SSD or communication module
- USB: USB 2.0 x 3
Package list:
1. Touch screen expansion board x1
2. Screws pack x1
3. Interface expander x1
2. 2.8 inch display with 5-point capacitive touch control, better touch experience from the fully laminated screen, together with 6H toughened glass panel, more safe to use
3. Touch Screen Expansion Board Introduction:
- CM4 socket: Suitable for all variants of Compute Module 4
- USB: USB 2.0 x 1
- Connector: MIPI CSI 22PIN 0.5mm camera connector
- Display: 2.8 inch fully laminated screen, 480 x 640 pixels, 5-point capacitive touch, toughened glass panel
- Video: Micro HDMI x 1, supports 4K 30fps output
- Storage: MicroSD card socket for Compute Module 4 Lite (without eMMC) variants
- Power input: 5V
4. Interface Expander Introduction
- Networking: Gigabit Ethernet RJ45; M.2 M KEY, support NVME SSD or communication module
- USB: USB 2.0 x 3
Package list:
1. Touch screen expansion board x1
2. Screws pack x1
3. Interface expander x1