Waveshare FT245 FT245RL USB to FIFO Module Communication Development Board Mini/T... (TYPE: TYPEA)

12 were available / new

R492.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3466

93.38 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

617560502

SELECTED OPTION:
TYPE: TYPEA

Feature:

1. FT245RL

USB independent chip for parallel FIFO bidirectional data transmission interface

Complete USB protocol processing chip-no specific USB firmware programming required

Based on 4-wire handshake connection, simple interface for MCU/PLD/FPGA logic

Data transfer rate up to 1 Megabyte/second-D2XX Direct Drivers

Data transfer rate up to 300kilobyte/second-VCP Drivers

256-byte receive buffer and 128-byte send buffer, using buffer smoothing technology to achieve high data throughput

2. USB interface

Provide two types of mini USB and type A USB interfaces to choose from

3. VCCIO power supply jumper

The jumper cap can be used to jump to VCCIO to access 5V or 3.3V voltage (VCCIO can be used to supply power to the VCC pin of the access board)

4. Power indicator

Module power indicator, easy to check the power supply status of the module

5. Interface

Connect to the corresponding interface of the single chip microcomputer

PIN Name	Type	Description
VCCIO	Power supply	It can be used to supply the FT245 chip or power to external devices, and can be set to 3.3V or 5V through the VCCIO jumper
GND	Power supply	Power ground
D0~D7	Input Output	FIFO data bus bits 0~7
NC	NC	Dangling
RST#	Input	Used to reset FT245
PWREN#	Output	After the USB configuration is successful, it is set low, and is pulled high when the USB is terminated
TXF#	Output	Does not write to FIFO when pulled high, data can be written to FIFO when TXF# is pulled low, and WR# is pulled high
RXF#	Output	Does not read FIFO when pulled high, when RXF# is pulled low, and RD# is pulled low, valid data of FIFO can be read
WR#	Input	Write to FIFO when pulled low
RD#	Input	Read FIFO when pulled low