This item has closed 1 buyer bought 2 items
View other items offered by DIYTECH1857

Similar products

Power Supply Board 24V 9A Power Module **LOCAL STOCK**
New
R450.00
Esp32/esp8266 Burner Usb-ttl Adapter Board Development Tool Esp-t01
New
R357.00
Battery Low Voltage Disconnect for 12V DC Battery Protection Module **LOCAL STOCK**
New
R49.00
Power Supply Board 24V 6A Power Module **LOCAL STOCK**
New
R365.00
Wifi Module ESP8266 ****LOCAL STOCK**
Sold

Wifi Module ESP8266 ****LOCAL STOCK**

New 2 were available
R75.00
Shipping
R65.00 Standard shipping applies to orders under R100.00, in most areas in South Africa. R35.00 Standard shipping applies to orders over R100.00. Some areas may attract a surcharge surcharge. This will be calculated at checkout if applicable.
Check my rate
The seller has indicated that they will usually have this item ready to ship within 5 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:
 
Standard Delivery
Main centres:  1-3 business days
Regional areas: 3-4 business days
Remote areas: 3-5 business days
Buyer protection
Get it now, pay later

Product details

Condition
New
Location
South Africa
Customer ratings:
Product code
MDL-WIFI
Bob Shop ID
235677298

 

SERIAL PORT WIFI MODULE ESP8266

SPECIFICATIONS:
 
  • 802.11 b/g/n
  • Wi-Fi Direct (P2P), soft-AP
  • Integrated TCP/IP protocol stack
  • Integrated TR switch, balun, LNA, power amplifier and matching network
  • Integrated PLLs, regulators, DCXO and power management units
  • +19.5dBm output power in 802.11b mode
  • Power down leakage current of <10uA
  • Integrated low power 32-bit CPU could be used as application processor
  • SDIO 1.1/2.0, SPI, UART
  • STBC, 1×1 MIMO, 2×1 MIMO
  • A-MPDU & A-MSDU aggregation & 0.4ms guard interval
  • Wake up and transmit packets in < 2ms

 

  • Standby power consumption of < 1.0mW (DTIM3)

NOTE:

This module requires a 3.3 volt supply for VCC, and 3.3V logic. It is not 5V tolant. Connect RX or TX on 5V Arduino will 

destroy this module. You must use a logic level converter, or a 3.3V Arduino 
 
The 3.3V supply on the Arduino Uno has inadequate current capabilit to power this module. You must provide a separate, 

 

higher 3.3V supply(about 300mA or better) 
 
 
 
PACKAGE INCLUDES:
 
1x Wifi Module (ESP8266)

 

Recently viewed

See more
3 Nested Boxes Little Milo
New
R599.00
DJI FPV REMOTE CONTROLLER 3
New
R3,299.00
33% OFF
How Language Works by Crystal David
Secondhand
R100.00 R150.00
Skipping Rope Adjustable Speed Skipping Jump Rope With Counter - Pink
New
R89.00

Customer ratings: 1 ratings

Great seller. Good communication and shipped fast.
02 Aug 2016