Name: XH-W1219 DC 12V Dual Display Digital Temperature Controller High Accuracy Tempe
SKU: 1311988
Price: 103.35 ZAR
Availability: SoldOut

XH-W1219 DC 12V Dual Display Digital Temperature Controller High Accuracy Tempe

30 were available / new

Indicative market price: R199.00

R103.35

48% off

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 3 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

Racer Gadgets10211

99.58 % Positive ratings

Buyer protection

How you're covered

Get it now, pay later

Condition

New

Location

International

Product code

1311988

Bob Shop ID

360664291

Package weight: 0.03 kg

Parameter:

Model: XH-W1219

Control range: -50°C to 110°C

Control accuracy: 0.1°C

Measurement input: NTC10K waterproof sensor L=0.5M

High temperature alarm: -49°C to 110°C

Input voltage: DC 12V

Output type: relay output up to 10A

Return difference setting: 0.1°C to 30°C

Delayed start: 0-10 minutes

Temperature correction: -10°C to +10°C

Size: 60*43*16mm (length*width*height)

How to restore factory settings:

Under normal power, press and hold the + and - key for about three seconds to restore factory settings.

1. PO temperature control mode:

This value must be set when the thermostat is used for the first time. If it is used for heating, it must be set to H. If it is used for cooling, it should be set to C.

2. P1 difference setting:

Press the SET button for a long time to enter the internal settings, select the P1 setting, and then press the SET button again to set the hysteresis value. (The hysteresis is the difference needed when the thermostat reaches the set temperature and stops working again.)

3. P2 temperature calibration:

This function is used for temperature calibration. If there is a deviation between the detected temperature and the actual temperature, this function can be used to correct. The corrected value = measured value + correction value. (If you do not control the compressor or do not need delay function, skip this item directly)

4. P4 high temperature alarm:

Set the high temperature alarm value. When the real-time temperature exceeds this value, the screen will flash warning alarm.

Package included:

1 X XH-W1219 dual display digital temperature controller