YAMAHA EXHAUST AND SUMP GUARDS

EXHAUST GUARDS:Remove any guards that may obstruct fitmentLoosen exhaust guard clampsRemove center bracket from guard and insert into the bike's frameInsert the threaded bar into the center bracket (without the nut)Loosen the rear bracket on the guard until it can move freely on the guardPush guard up on to the bike frame: Align and attach rear bracket / capscrews first. Next, aligncenter holes with the threaded bar, and fit hose clamps over the exhaustFit fender washer and hex nut on to the threaded bar and tighten guard up to the frame*Do not overtighten the bolts as this may damage the guardInsert capscrew into the second hole of the middle clamp and tighten. Remove threaded bar andreplace with capscrew. TightenApplying upward pressure on the front of the guard, tighten exhaust clamps. Apply silicone to thebase of the capscrews to stop the bolts from loosening. Apply silicone to the clamp to hold it tightlyin place on the frameWarningRubber grommets need to be replaced if missing to prevent melting of the guard. The guard must only be used on theexhaust pipe it was intended for otherwise contact may occur with the guard and the pipe, resulting in the melting ofthe guard ie. only the rubber grommets may touch the exhaust pipe. More grommets may be added to the guard ifpreferred - these are available on order from your nearest dealerAfter first fitment the guard will conform to the shape of the frame once heating and cooling has occurred to ensure a great fitIMAGE MIGHT DIFFER FROM ACTUAL PRODUCT