ZYDTEK ZY-36 For Oculus quest 2 VR Charging Seat Handle Storage Wall Hanging Frame(White)
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Product code
TBD0603136901A
Bob Shop ID
597484987
1. Super magnetic charge
2. Has a certain degree of plasticity, can change according to the size of the handle, even wearing a silicone sleeve handle can be put down
3. Non-slip silicone to prevent the charging seat from sliding off the desktop
4. Charge the breathing light. The breathing light will come on when you charge it
5. Material: ABS
6. Size: 30x11.5x8.5 cm
7. Net weight: 270g
Desktop usage steps:
1. Insert the magnetic USB connector into the helmet charging port
2. Fix the nose bracket
3. Plug the USB-C cable into the device's charging port; switch to ON
4. Place the helmet on the charging dock
5. Wait 2-3 seconds, until the right side of the helmet LED Red Light, if failed, please re-prevent the helmet
6. Insert the handle into the hole
The wall surface uses the step:
1. Mark the screw holes on the wall with a locator card
2. Insert the anchor and screw it into the wall. Keep the bolt 5 mm away from the wall
3. Hang the charging dock on a screw
4. Plug the magnetic USB connector into the helmet charging port
5. Fix the nose bracket
6. Plug the USB-C cable into the device's charging port; switch to ON
7. Place your helmet on a charging pad
8. Wait 2-3 seconds, until the right side of the helmet LED Red Light, if failed, please re-prevent the helmet
9. Insert the handle into the hole