L293D Motor Driver IC
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
EC-056
Bob Shop ID
614718137
This is a monolithic integrated high voltage, high current four channel driver designed to accept standard DTL or TTL logic levels and drive inductive loads (such as relays solenoids, DC and stepping motors) and switching power transistors. To simplify the use as two bridges each pair of channels is equipped with an enable input. A separate supply input is provided for the logic, allowing operation at a lower voltage and internal clamp diodes are included. This device is suitable for use in switching applications at frequencies up to 5 kHz.
The L293D is assembled in a 16 lead plastic package which has 4 centre pins connected together and used for heatsinking
Specifications:
- Voltage: 4.5V - 36V
- 600mA Output Current Capability per Channel
- 1.2A Peak Output Current (non-repetitive)
- Overtemperature Protection
Datasheet: L293D motor driver
Code
int motorpin1 = 3;Code
int motorpin1 = 3;
int motorpin2 = 4;
void setup () {
pinMode(motorpin1,OUTPUT);
pinMode(motorpin2,OUTPUT);
}
void loop () {
digitalWrite(motorpin1,LOW);
digitalWrite(motorpin2,HIGH);
} int motorpin2 = 4; void setup () { pinMode(motorpin1,OUTPUT); pinMode(motorpin2,OUTPUT); } void loop () { digitalWrite(motorpin1,LOW); digitalWrite(motorpin2,HIGH); }