K20 K24 K-series Tucked Harness for Honda Acura K-swap Integra
10 were available / new
R1,954.00
0% off
Shipping
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 12 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
Replacement Guarantee:
7 Days: We stand by this guarantee
Get it now, pay later
Product details
Condition
New
Location
International
Bob Shop ID
613509184
The Tucked Engine Harness is designed as a high quality replacement 02-04 RSX Type-S harness that offers a super clean look. We have made the harness with lots of features so it will work with nearly all K-Series engine swaps and the 02-04 RSX Type S.It includes all the necessary plugs with a handful of extras (Fan Switch, IACV, Temp Sensor, ETC).It is rated for -55 C to 150 C (-67 F to 320 F). We have also used a popular and clean tucked wire layout. The main harness runs over the valve cover and even hides the injector plugs, which come up from under the manifold. OBD2 HONDA injector plugs come with all harnesses.On swap chassis, the power wire will work with fuse box in factory location or relocated under the dash. Separate power wire is available for other chassis and those that prefer to run their own charge wiring. Everything is labeled clearly to ensure a simple installation and no confusion.K20 K24 Engine HarnessApplications:K-Swap Cars02-04 RSX Type S02-04 RSX Base01-05 Civic EP3 (Type S or K24 Swap)Note:New design uses factory RSX connectors.Will NOT fit RHD cars or RWD cars.Features:All plugs included except EVAP and ACCovering is gas and crude oil resistant and rated for -55 C to 150 C (-67 F to 320 F)SAE Certified Automotive Grade WiringAll plugs are labeledTucked designHarness runs over valve cover (Can be covered with coil pack cover)Injector wiring runs from under manifold between middle runners.Ground wire relocated to stud under coil pack cover (instead of front of the valve cover)Includes single wire temp sensor wire (For k-swap cars stock cluster)3 Aux wires run from ECU to under intake manifold. Two ECU pins pre-installed.Wiring long enough for both VSS low frequency or high frequency (High Frequency transmissions will require repining plug and slight modification to VSS)Each harness is inspected and tested before shipping.RSX injectors plugs come standardMaterial:ABScolour:BlackPackage Contents:1 x Engine Wire HarnessOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.