0-120C Universal Capillary Thermostat Temperature Controller Cooling Car Radiator Fan Control Swit
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615097819
Features:
a?? Temperature control template: 0-120?ﾣ C
a?? Variable Capillary Thermostat Control Switch
Allows you set the temperature you wish the cooling fan to operate
a?? The Fan will kick in at the selected temperature and then switch of when the engine temperature goes back down
a?? To fit in the hose simply remove the top radiator and fully insert the probe, then re fit hose and tighten over the capillary wire being extra careful not to damage the probe inside. Silicone sealant can be used to help seal if required.
Wiring Instructions:
C Terminal = 12V Feed
No2 Terminal= Power out to the fan
(the switch is earthed through the fan)
No1 Terminal= Leave blank, this is not required for this application
You can also wire a relay in if you wish, but this is not a requirement.
Package Included:
1x Universal Temperature Controller
a?? Temperature control template: 0-120?ﾣ C
a?? Variable Capillary Thermostat Control Switch
Allows you set the temperature you wish the cooling fan to operate
a?? The Fan will kick in at the selected temperature and then switch of when the engine temperature goes back down
a?? To fit in the hose simply remove the top radiator and fully insert the probe, then re fit hose and tighten over the capillary wire being extra careful not to damage the probe inside. Silicone sealant can be used to help seal if required.
Wiring Instructions:
C Terminal = 12V Feed
No2 Terminal= Power out to the fan
(the switch is earthed through the fan)
No1 Terminal= Leave blank, this is not required for this application
You can also wire a relay in if you wish, but this is not a requirement.
Package Included:
1x Universal Temperature Controller