1Pcs Carbon Fiber Central Control Gear Box Decorative Panel for Chevrolet Camaro 2019
10 were available / new
R967.00
0% off
Shipping
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable. Check my rate
The seller has indicated that they will usually have this item
ready to ship within 15 business days.
Shipping time depends on your delivery address.
The most accurate delivery time will be calculated at checkout,
but in general, the following shipping times apply:
100% Original and Good Quality with Free After-sale Warranty. Location: Cup Holder Center Console Category: Car interior Accessories Condition:100% Brand-new & High Quality, Real Carbon Fiber Easy installation, just simply peel and stick on Surface must be clean and dry prior adhering not easy to peel off High Degree of Fit with the original car. High Quality Adhesive, not leave traces after tearing off, not damage the original car. Type: Central control gear frame decoration Type Of Sticker: Carbon Fiber Protector Installation Guide: 1. Cleaning The Installation Site In Advance (general Cleaning Can Be Used Without Fiber Dropped Cloth Dipped In 50% Alcohol) 2. Make Sure The Installation Site Is Clean, Dry And Dust-free. 3. Before Pasting The Trim Should Be Put It In The Installation Position Well And Make Adjustment,after Assuring The Position, Peel Off The Double-sided Adhesive On The Back Of The Trim, And Use The Lighter To Heated It Slightly, Then Aim At Right Position And Press Strongly. 4. It Is Better That Don't Press The Water For 2-3 Days Before Installation, Otherwise It Will Affect Its Adhesion. Colour: Carbon fiber pattern Material: carbon fiber Package Contents: 1 x Central control gear frame decoration Only the above package content, other products are not included. Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.