MX1616 H-Bridge DC Motor Driver
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
MOD-188
Bob Shop ID
614718175
MX1616 H-Bridge DC Motor Driver
This Dual H-bridge motor driver can drive two DC motors or a 4-wire two-phase stepper motor. With built-in TSD (thermal shut down), you don't have to worry about motor stall Its ultra-small size, makes it suitable for driving the N20 Micro Metal Motors.
The MX1616 also called mini L298N motor driver has two input power pins: VS and VSS. VS pin powers the IC's internal H-Bridge, which drives the motors. This pin accepts input voltages ranging from 5 to 12V. VSS is used to power the logic circuitry within the L298N IC and can range between 5V and 7V.
Technical specifications:
- Module supply voltage: 2V~10V
- Signal input voltage: 1.8-7V
- Single working current: 1.5A (Max 2A require cooling)
- Low standby current (less than 0.1uA)
- Built-in common conduction circuit, the input terminal vacant, the motor does not malfunction
- Size: 24.7 x 21 x 5mm