1A LIPO Charger Module with Protection
New
Indicative market price: R50.92
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 2 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
3056
Bob Shop ID
613700926
Here is an example of DIY 18650 Charger using a TP4056 Lithium Cell Charger Module by Tinker Man Mick:
Note: Stock is currently available in South Africa for national shipping!
Single-cell lithium base battery charger & protection module. The charging will be via a micro B connector. Lithium base battery includes Li-po and Li-ion battery as the charging and discharging characteristic is similar.
The USB micro B connector power input offers direct charging using widely available nowadays with power bank and also Android phone charger. With a maximum charging current of 1A, your battery can be charged faster and of course, do make sure the 5V input has sufficient power to provide more than 1A.
It comes with a TP4056 charging IC.
Using the module
- Connect micro USB cable for power, or 5V DC to pads marked IN+ and IN- on left-hand side of the module
- Connect cell to charge to B+/B- pads on right-hand side of module
- A load (something for the battery to power) can be connected to the OUT+/OUT- pads on the right-hand side
- Important! Disconnect load when charging
- The red LED indicates chaging in progress, green LED indicates charging has finished.
- Never charge your battery at a rate greater than 1C.
Features
- Single Cell Lithium-based battery charger.
- USB Micro B connector for power input
- 5V input pads for DIY/custom input.
- Input Voltage: 5VDC
- Charging voltage limit: 4.2VDC
- Minimum discharge voltage: 2.5VDC
- Maximum discharge current: 3A
What's in the box?
1 x 1A LIPO Charger Module with Protection
Resources
DIY: Lithium 18650 Cells Charger by Using TP4056 Modules, in Instructables with video, by Well Done Tips