This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1654
Similar products
1 Channel 24V Relay Module Optocoupler Isolation With Indicator Input Active Low Level BESTEP for Ar
New
R355.00
Closed
11 May 24 00:03
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612367012
Description: ? Normally open interface maximum load: AC 250V/10A, DC 30V/10A. SMD optocoupler isolation, strong driving capability, stable performance; trigger current 5mA. Fault-tolerant design, the relay will not move even if the control line is broken. Power indicator (green), relay status indicator (red). The interface is designed humanized, and all the interfaces can be directly connected by wiring terminals, which is very convenient.
Two module interface: ? 1. DC+: Connect the power supply positive pole (voltage 24V). 2. DC-: Connect the power negative pole. 3. IN: Low level (24V) control relay pull in. ? Relay output terminal: ? 1. NO:?Relay normal open, the relay suspends before pulling in, and then short-connect with the COM. 2. COM: Relay common interface 3. NC:?Relay normal close,?short connected with COM before?pulling inand suspended after?pulling in. ? Package Included:
1 x?1 Channel 24V Relay Module ?
Two module interface: ? 1. DC+: Connect the power supply positive pole (voltage 24V). 2. DC-: Connect the power negative pole. 3. IN: Low level (24V) control relay pull in. ? Relay output terminal: ? 1. NO:?Relay normal open, the relay suspends before pulling in, and then short-connect with the COM. 2. COM: Relay common interface 3. NC:?Relay normal close,?short connected with COM before?pulling inand suspended after?pulling in. ? Package Included:
1 x?1 Channel 24V Relay Module ?