This item has closed with no items sold
View the relisted Item
View the relisted Item
View other items offered by szulou1654
Similar products
15W18W24W LED Thyristor Dimming Power Supply Ceiling Lamp Downlight Driver Track L... (TYPE: DCLINE)
New
R378.00
Closed
11 May 24 00:04
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Buyer Protection
How you're covered
Get it now, pay later
Returns
Product information
Condition:
New
Location:
International
Bob Shop ID:
612368239
SELECTED OPTION:
TYPE: DCLINE
1. Non-isolated output, high-power LED dimming driver, please pay attention to the safety of use, and the housing is electrically insulated. 2. F15-24X1W driver is designed for dimming 15-24 1W high-power LED lamps, the lamp beads must be connected in series.
Parameter:
Product model: F15-24 non-isolated dimming driver Input voltage: 180~265V/AC Grid frequency: 50/60Hz Input current: 0.2A Inrush current: 2A (500nS) Power factor: 0.6 Power efficiency: 89% Output voltage: 45~80V Output current: 220~300 mA Open circuit protection: no-load power consumption 1.20W (It is not recommended to output a long-term open circuit to avoid damage to the protection components) High temperature protection: if the power supply temperature exceeds 150?ﾣC, the output will be turned off, and the output will be restored when the temperature drops to 90?ﾣC. Ambient temperature: -20a??~ +45a?? Environmental humidity: 20~ 50 RH Bare board size: 51 X 21 X 18 MM Weight: 20 g Input wiring: external_brown (live wire L), blue (zero wire N); built-in_white (live wire L); white (zero wire N) Output wiring: external_red (positive+), black (negative-); built-in_red (positive+), white (negative-)
Note:
For built-in use, it is forbidden to use heat-shrinkable tubing for insulation, it must be wrapped with insulating paper, and vents must be left at the input and output ends to facilitate heat dissipation of the power supply. Note for use: This power supply is non-isolated, please connect the lamp and then power on, otherwise it will burn the lamp source! ! !
