3Pcs Keyes Brick Collision Sensor (pad hole) with Pin Header Module
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615098505
Description:
This sensor is fully compatible with ARDUINO single-chip microcomputer, and its connection port is also compatible with arduino sensor expansion board. The sensor inputs a key signal and can output a digital voltage signal. When the sensor presses the button due to a collision object, the sensor signal terminal outputs a low level signal, and when the button is released, the sensor signal terminal maintains a high level. The sensor can be used as a position switch in a 3D printer. The sensor comes with 2 positioning holes, which is convenient for you to fix the sensor to other equipment.
Specification:
Operating voltage: 3.3V-5V (DC)
Interface: 3PIN interface Output signal: digital signal Size: 38*22*6mm Weight: 2.7g(1pcs)
Package included:
3 x Collision Sensor (the UNO does not includes)
This sensor is fully compatible with ARDUINO single-chip microcomputer, and its connection port is also compatible with arduino sensor expansion board. The sensor inputs a key signal and can output a digital voltage signal. When the sensor presses the button due to a collision object, the sensor signal terminal outputs a low level signal, and when the button is released, the sensor signal terminal maintains a high level. The sensor can be used as a position switch in a 3D printer. The sensor comes with 2 positioning holes, which is convenient for you to fix the sensor to other equipment.
Specification:
Operating voltage: 3.3V-5V (DC)
Interface: 3PIN interface Output signal: digital signal Size: 38*22*6mm Weight: 2.7g(1pcs)
Package included:
3 x Collision Sensor (the UNO does not includes)
