EleksMaker PWM To TTL Transition Module for Laser Engraving Machine Controller Board Mana SE IVAxi

12 were available / new

R476.00

Shipping

R35.00 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30.00 surcharge. This will be calculated at checkout if applicable.
Check my rate

The seller has indicated that they will usually have this item ready to ship within 12 business days. Shipping time depends on your delivery address. The most accurate delivery time will be calculated at checkout, but in general, the following shipping times apply:

Standard Delivery

Main centres:	1-3 business days
Regional areas:	3-4 business days
Remote areas:	3-5 business days

Seller

szulou3532

93.44 % Positive ratings

Buyer protection

How you're covered

Returns

Replacement Guarantee: 7 Days: We stand by this guarantee

Get it now, pay later

Condition

New

Location

International

Bob Shop ID

617641980

Description:
This PWM TO TTL transition module is design for EleksMaker series machine and its controller board. But it can also be used for other DIY machine which need to transform?the modulation from?PWM to TTL.

Specification:
Power Port Size: 5.5*2.1mm
Working Voltage: DC 12V
Woring Power: >2A
Weight: About 10g

FAQs & Instructions:
1. When or why I need to have a?PWM TO TTL transition module?
As known, ?Eleksmaker??controller board is designed with a 3-pin port (12V/GND/PWM) for connection to laser module with the same port. ?However, if your laser module is designed as 2*2.54-2P port (2*2-pin port, usually power port and TTL port), it can not be directly used on EleksMaker series machine. Therefore, you need to have a PWM TO TTL transition module.?

2. How to use this transition module? (How to?transform?PWM to TTL?)
You can see 3 port on the transition module.
(They?respectively are Input Port (3-Pin, White), Output Power Port (2-Pin, Red), Output TTL Port (2-Pin, White).
a?? Connect Input Port to EleksMaker Machine Controller Board Mana SE / Mana / IVAxis.
a?? Connect Output Power Port to the power port on your laser module.
a??? Connect Output TTL Port to the TTL Port on laser module.
a??? Power on ManaSE board.

3. How to test whether the laser module is broken?
You can also see a DC Port?on the transition module. It can be used to test whether your laser module works or not.
Connect the DC Port with power supply.
Connect?Output Power Port?to the power port on your laser module.
Plug in power, press the button on the transition module---laser off; release the button--- laser on. Then it means laser works fine.

Package Included:
1 x?PWM TO TTL transition module