Low Level 5V 4 Channel Solid State Relay Module SSR G3MB-202P 240V 2A Output with Resistive Fuse

Omron 5V solid state relay 240V 2A, the output with a resistive fuse 240V 2A.
Input power: 5V DC (160MA)
input control signal voltage:
Low level module: (0-2.5V state low level relay OFF)
(3.3-5V state high level relay ON)

size: (L * W * H mm) 
    1 channel: 25 * 34 * 25
    2 channel: 55 * 33 * 25
    4 channel: 57 * 55 * 25
    8 channel: 106 * 56 * 25

Input section

DC +: Connect the power supply positive (according to the relay voltage)
DC-: Connect the power supply negative
CH1: 1 relay module signal trigger terminal (low level trigger active)
CH2: 2 relay module signal trigger terminal (low level trigger active)
CH3: 2 relay module signal trigger terminal (low level trigger active)
CH4: 2 relay module signal trigger terminal (low level trigger active)

High and low meaning

High-level trigger refers to the signal trigger side (IN) and the negative power supply has a positive voltage between the positive and the power supply is usually connected to the trigger side of a trigger, when the trigger side voltage or trigger to reach the trigger Voltage, the relay is pull.

Low-level trigger refers to the voltage between the signal trigger terminal and the negative terminal of the power supply is OV, or the voltage of the trigger terminal is lower than the voltage of the positive terminal of the power supply. When the voltage is low enough to trigger, the relay is pulled in, The negative side of the power supply is connected to the trigger side of a trigger, so that the relay is pull.

Electrical parameters

Voltage Version Quiescent Current Operating Current Trigger Voltage Trigger Current
 1 channel 5V 0mA 12.5mA 0-2.5V 2mA
 2 channel 5V 0mA 22.5mA 0-2.5V 2mA
 4 channel 5V 0mA 48mA 0-2.5V 2mA
 8 channel 5V 0mA 102mA 0-2.5V 2mA

What's in the box?

1 x solid state relay

Resources

Instructions

1. Module power supply: the power must be DC, the voltage and the relay voltage to match
2. Wiring method:
When the trigger side of the signal trigger level, the relay will be connected, the device has electricity and work

Notes
 
1. Module power supply: power must be DC, 5V power supply
2. Module control terminal voltage: This module can only be used to control AC current, can not control DC current.