MAX7219 Dot Matrix Module Microcontroller LED Module Display Module MAX7219 DIY Kit
New
Shipping
Standard courier shipping from R30
R30 Standard shipping using one of our trusted couriers applies to most areas in South Africa. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 15 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Returns
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
International
Bob Shop ID
615101938
Description:
?? A single module can drive an 8*8 common negative lattice
?? Module operating voltage: 5V
?? Module size: 3.2 cm long, 3.2 cm wide and 1.5 cm high
?? With 4 fixed screw holes and 3 mm diameter, it can be fixed with M3 copper column.
?? Modules with input and output interfaces support multiple modules cascade
Wiring instructions:
The left side of the module is the input port, and the right side is the output port.
When controlling a single module, you only need to connect the input port to the CPU.
When multiple modules are cascaded, the input end of the first module connects to the CPU, the output end connects to the input end of the second module, the output end of the second module connects to the input end of the third module, and so on.
Take 51 single chip computer as an example:
?? VCC 5V
?? GND GND
?? DIN_P20
?? CS_P21
?? CLK_P22
Package included:
1 x MAX7219 Dot Matrix Module DIY kit
?? A single module can drive an 8*8 common negative lattice
?? Module operating voltage: 5V
?? Module size: 3.2 cm long, 3.2 cm wide and 1.5 cm high
?? With 4 fixed screw holes and 3 mm diameter, it can be fixed with M3 copper column.
?? Modules with input and output interfaces support multiple modules cascade
Wiring instructions:
The left side of the module is the input port, and the right side is the output port.
When controlling a single module, you only need to connect the input port to the CPU.
When multiple modules are cascaded, the input end of the first module connects to the CPU, the output end connects to the input end of the second module, the output end of the second module connects to the input end of the third module, and so on.
Take 51 single chip computer as an example:
?? VCC 5V
?? GND GND
?? DIN_P20
?? CS_P21
?? CLK_P22
Package included:
1 x MAX7219 Dot Matrix Module DIY kit