Metalrite Coast Primer MR200 is an anti-corrosive acid etch
primer for all clean galvanized iron and non-ferrous metals. A
Pre-treatment primer for new steel surfaces, clean galvanized
steel, roof metal sheet and Chromadek. Contains Zinc
Phosphate which provides excellent anti-corrosive properties. It
may be over-coated with a wide range of topcoats such as
alkyds, vinyl and water-based acrylic paints.
Intended Uses:
Ideal for use on vehicle chassis and under body components,
engine parts, gates, palisade fencing, metal replaces and
burglar bars and security gates.
- Features & Benefits:
- For coastal & inland conditions
- Excellent anti-rust primer
- Excellent durability & adhesion
- For new & weathered mild steel, galvanised iron,
Chromadek, Aluzinc & IBR. - Quick dry to a hardwearing primer
- Interior and exterior use
Surface Preparation:
Ensure that the surface is properly dry and in sound condition,
free from dust, grease, oil, algae, fungus or any loose particles
before painting.
Do not apply if rain is imminent. Apply at an ambient
temperature of 10°C to 35°C. Ensure good ventilation.
Quick drying - avoid application to very hot surfaces.
NEW SURFACES
Galvanised Iron, Aluminium and all non-ferrous metals:
Clean and degrease with METALRITE GALVANIZED IRON
CLEANER Iron Cleaner until a water break free surface is
obtained. Apply one or two coats METALRITE COAST PRIME
MR200, depending on the severity of the conditions. Ensure
that surfaces are dry, sound, and free from dust, dirt, grease
and oil before painting.
Mild steel:
Degrease with good degreaser. Rinse thoroughly with water.
Remove any rust by coarse sanding, mechanical grinding or
METALRITE RUST REMOVER. Rinse thoroughly with water and
allow drying.
PREVIOUSLY PAINTED SURFACES
Thoroughly clean and prepare surface by removing all dirt,
grease, grime and flaking/peeling paint before painting. Treat
as new surface.
