Solderless Pre-wired Electronics for Les Paul, SG or similar with 1V1T without Jack and Switch

Includes Full-Size Brass Shaft A500K potentiometers for Volume and Tone with 0.022uf Capacitors, modern Gibson wiring layout, Duncan treble bleed mod on Volume.

Includes all the necessary nuts and washers. Controll knobs not included, please purchase them separately if you need

This is for those wanting to change their potentiometers and related components only and use their existing switch and jack. You need to feed the wires from the switch through your cavity to the potentiometer cavity, then connect the switch wires and pickup wires to the solderless connector on top of the pot, the output jack wires and bridge ground get connected to the solderless connector too. We also offer this wiring assembly without solderless connectors, please see our listing for that one should you require solder-in harness. We also sell prewired harnesses with the jack and switch soldered in already but these will only work for guitars like SG, where the wiring does not need to go through different cavities, such as a Les Paul Standard which has the switch at the top of the guitar and pots at the bottom.

Please note when ordering custom pickguard wiring or electronic assemblies, add an extra 24 - 48 hours to the lead time.