Dual L298N H-Bridge Stepper Motor Driver 2A
New
Shipping
Standard courier shipping from R60
R60 Standard shipping applies to orders under R100, in most areas in South Africa. R30 Standard shipping applies to orders over R100. Some areas may attract a R30 surcharge. This will be calculated at checkout if applicable.
Check my rate
Check my rate
Ready to ship in
The seller has indicated that they will usually have this item
ready to ship within 3 business days. Shipping time depends on your delivery address. The most
accurate delivery time will be calculated at checkout, but in
general, the following shipping times apply:
Standard Delivery
| Main centres: | 1-3 business days |
| Regional areas: | 3-4 business days |
| Remote areas: | 3-5 business days |
Get it now, pay later
Seller
Buyer Protection
Product details
Condition
New
Location
South Africa
Product code
MOD-040
Bob Shop ID
614719035
Dual L298N H-Bridge Stepper Motor Driver 2A
The L298N is ideal for building robots or anything else you want to be able to move. It can drive two quite powerful motors totally independently and will work quite well with our robot chassis. You can also take a look at our wheels and motors.
L298N H-Bridge Specification
- Motor supply: 7 to 24 VDC
- Control Logic: Standard TTL Logic Level
- Output Power: Up to 2 A each
- Enable and Direction Control Pins
- Heatsink for IC
- Power-On LED indicator
- 4 Direction LED indicators
- ENA Motor A Enable Input
- IN1 Motor A Direction Control Input 1
- IN2 Motor A Direction Control Input 2
- IN3 Motor B Direction Control Input 2
- IN4 Motor B Direction Control Input 1
- ENB Motor B Enable Input
- +12v Motor Supply Voltage (7 — 35VDC) (Can be used for logic supply as well)
- GND Ground
- +5v Logic Supply Voltage (4.5 — 7VDC) (Regulator output can be used from this pin)
- OUT1 Motor / Bridge A Output
- OUT2 Motor / Bridge A Output
- OUT3 Motor / Bridge B Output
- OUT4 Motor / Bridge B Output